- Aktuelles (Start)
- E-Autos
- Fahrzeuge & Tests
- Fuhrpark & Flotte
- Wirtschaft & Politik
- Messen & Events
- Eigene Veranstaltungen
- Videos
- Branchen-Jobs
- Automotive-Newsletter
- Fachmagazin & Abo
- Suche
- English Content
- 最新汽车新闻（中文版
- Weitere Inhalte
Many independent developers have created custom .MOD and .IDX library files specifically for the EGS002 or EG8010.
Proteus does not include the EGS002 or EG8010 chip in its default master library. You must install a third-party custom library. Step 1: Download the Library Files
The EGS002 is a driver board that integrates three key components: egs002 proteus library
Search for "EG8010 Proteus model" or "EGS002 library file." Reliable sources include:
In the field, link the .HEX file that came with your library. Connect Power and Gates: Many independent developers have created custom
The EGS002 requires voltage feedback to stabilize the output sine wave. In the simulation, you must connect a resistive voltage divider from the output back to the voltage feedback pin on the driver model to observe the regulation behavior.
Search for the IR2110 in the Proteus device library. Place two IR2110 IC models on your workspace to mirror the driver stage of the EGS002. Connect the microcontroller SPWM outputs to the HIN (High Input) and LIN (Low Input) pins of the IR2110 chips. Constructing the Complete Inverter Schematic Step 1: Download the Library Files The EGS002
Before finding a simulation path, it is crucial to understand what the EGS002 is. The module is a pre-assembled driver board with a 17-pin interface, designed as a complete control sub-system for an inverter. Its brains are two integrated circuits: the EG8010 and the IR2110S.
Set the “Processor Clock Frequency” in Proteus to match the EG8010’s external crystal (usually 6MHz or 12MHz – check the library model). Press play. You should see clean SPWM pulses in the oscilloscope.
Over-current protection that shuts down the SPWM signals if the H-bridge encounters a short circuit or overload. Simulating the EGS002 in Proteus
: SPWM frequency operates around 23.4kHz. Simulating high-frequency switching alongside an analog H-bridge strains the Proteus solver. To fix this, change the simulation time step by going to System -> Set Simulator Options and adjusting the SPWM parameters.