Media Converter In - Cisco Packet Tracer Link ((hot))

Drag a (Fast Ethernet Copper) or PT-SWITCH-NM-1CGE (Gigabit Ethernet Copper) module into an empty slot.

Note: Some devices are "Fixed Configuration," while others are "Modular." You need a device with an slot. 2. Add the Fiber Module (SFP) Click on the Switch to open its configuration window. Go to the Physical tab.

A is a simple Layer 1 (Physical layer) device. It does not read IP addresses, MAC addresses, or make routing decisions. Its job is straightforward: media converter in cisco packet tracer link

Trying to connect a copper RJ-45 port to a fiber optic slot using a copper cable will result in a connection error. Always look for the dashed orange line for fiber connections. If you want to optimize your topology further, let me know:

Have you tried building a redundant fiber ring in Packet Tracer? Let me know in the comments below! Drag a (Fast Ethernet Copper) or PT-SWITCH-NM-1CGE (Gigabit

What (routers, switches, or end devices) are you trying to connect?

This article explores what a media converter is, how it functions in Packet Tracer, and how to create a working media converter link. What is a Media Converter? Add the Fiber Module (SFP) Click on the

Set the IP address to 192.168.1.20 with a subnet mask of 255.255.255.0 . 2. Run a Ping Test Open the desktop of PC0 and click on the . Type ping 192.168.1.20 and press Enter.

Note: Ensure your PC has a Fiber NIC installed. If not, go to the PC physical tab, turn it off, replace the module with a Fiber NIC, and turn it back on. 4. Verify the Link