Plotter Usb Driver Install | Redsail Cutting

. You’ll likely see a yellow exclamation mark under "Other Devices". The Manual Search : Right-click the unrecognized device and select "Update Driver Software" . Instead of searching automatically, choose "Browse my computer for driver software" and point it to your driver disk or downloaded folder. Verification : Once installed, the device should transform into "USB-SERIAL CH340 (COMx)"

Connect your Redsail plotter to the computer using the USB cable and turn the machine power on. Press and select Device Manager .

Use :

Choose the COM port number you found in the Device Manager (e.g., COM3). Set Baud Rate: The default is usually 1920019200 redsail cutting plotter usb driver install

: Always plug your Redsail plotter into the exact same physical USB port on your computer. If you switch to a different USB port later, Windows will assign a new COM port number, and your software will stop cutting until you update the settings. Step 4: Configure Your Cutting Software

If USB driver fails completely:

In the device selection window, choose as the manufacturer and select your specific model (e.g., RS720C, RS1360C). Click on Link To . Use : Choose the COM port number you

Yes. Most Redsail cutting plotters – including the RS360C, RS720C, RS800C, RS1120C, and RS1360C – use the same CH340 or FTDI chipset for USB communication. The driver is chipset‑specific, not model‑specific. Once the driver is installed, any Redsail cutter using the same chip should work.

Sometimes, the issue is not the driver but the physical connection. Ensure the USB cable is securely plugged in.

By following these steps, you should be able to successfully install the USB driver for your Redsail cutting plotter. Instead of searching automatically

If Device Manager shows a yellow exclamation mark, the driver did not install correctly. Right-click in Device Manager. Select Update driver > Browse my computer for drivers .

Usually, you need the CH340/CH341 driver. 2. Preparing for Installation Before starting, ensure you have the following ready: Your Redsail Plotter (powered on). USB Cable (A-B type). A Computer running Windows.