Autoclave Manual - Sanyo Mac 1200

Operating the Sanyo MAC-1200 requires strict adherence to protocol to prevent sample spoilage or physical injury. 1. Pre-Operational Checks

Approximately 22 to 24 liters (depending on the exact sub-model revision).

Cause: Blown fuse, tripped circuit breaker, or faulty power cord. sanyo mac 1200 autoclave manual

Routinely run spore tests (such as Geobacillus stearothermophilus ) to verify that the autoclave is successfully killing all microbial life. Troubleshooting Common Errors

Do not autoclave solvents, volatile liquids, or radioactive materials, as they can cause toxic fumes or explosions. Operating the Sanyo MAC-1200 requires strict adherence to

: Triggered if the unit fails to reach 121°C. Check water levels and ensure the chamber is not overloaded. Routine Care : Wipe the chamber with a soft cloth after use.

Set the timer based on the load type (standard loads usually require 15–20 minutes). 4. Starting the Process Close the lid firmly and engage the locking handle. Press the "Start" button. Cause: Blown fuse, tripped circuit breaker, or faulty

Do not pack the chamber too tightly; steam must reach every surface.

Often 50 liters or larger, featuring a cylindrical SUS304 stainless steel chamber. 2. Installation and Initial Setup Proper installation is crucial for safe operation.